Gutting the Glute-Ham Raise

The first problem with the glute-ham raise is the name. Most lifters can't objectively analyze an exercise if the exercise's name is misleading.

Case in point, back extensions. Flex and extend the spine with the pad at your navel and it's indeed a back extension, which targets the erectors dynamically and the hip extensors statically.

But place the pad at upper thigh-level and flex and extend the hips while keeping the core stiff and now it's a hip extension exercise that works the erectors statically and the hip extensors dynamically.

Many people perform hip extensions thinking they're targeting their erectors, when in reality they're working the glutes and hamstrings to a much greater degree. Conversely, many people perform back extensions thinking they're targeting their hip extensors, when they're actually working their erectors more.

Back to the glute-ham raise – this is another example of a confusing name. Put the word "glute" in the title and you somehow dupe an entire industry for forty years!

Though European athletes had been performing the movement since the turn of the 20th century, most Americans first learned of the glute ham raise through a 1971 Strength and Health magazine article where Russian weightlifters were performing the movement on a pommel horse in front of wooden stall bars. Later came the various exercise apparatuses such as the glute-ham developer and the poor man's glute-ham.

I've seen all kinds of names for the exercise over the years and many ways to perform it.

You have a glute-ham-gastroc raise that's performed off a specialized apparatus. (I sometimes wonder why it wasn't called an erector-glute-ham-gastroc raise as the erectors fire harder than the glutes in terms of percentage of maximum voluntary isometric contraction).

Usually these are intended to be initiated from a 90° hips-flexed position by way of an initial hip extension motion followed by a knee flexion motion that ends in a 90° knee-flexed position.

Then you have the shortened motion glute-ham raise, which is also performed off a glute-ham developer but eliminates the initial hip extension motion, so you're only lowering down until the torso is parallel to the floor.

Then you have off-shoots: the Russian leg curl, Russian lean, Russian ham curl, kneeling Russian hamstring curl, Nordic ham curl, Nordic hamstrings, Nordic hamstrings lower, Nordic leg curl, Nordic reverse curl, glute-ham curl, bodyweight leg curl, natural hamstring curl, and bodyweight hamstring curl, to name a few.

These typically involve kneeling on a pad and lowering under control while the ankles are held in place by a partner, a lat pulldown apparatus, a sit-up apparatus, a loaded barbell, a poor man's glute-ham apparatus, or any other immovable object you can think of using.

These are all amazing hamstring exercises, but guess what? They're all lousy glute exercises.

If you consult the literature, you'll find a couple studies that show that the glute-ham raise and Russian leg curl are both great hamstring exercises.

Ebben (2009) showed that the glute-ham raise elicited 98% mean hamstring activation normalized to MVC, and Zebis, et al. (published ahead of print) showed that the Russian leg curl elicited 82% and 91% peak semitendinosus and biceps femoris activation, respectively, normalized to MVC. However, neither of these studies measured gluteus maximus EMG, though.

The next best thing is to examine the results that I got when I conducted my own EMG experiments on myself (I own an Elitefts Glute-Ham Developer).

Here's what I found, normalized to MVC:

You'll notice that you get more glute activity when the knees are further away from the top of the pad compared to when the knees are close to the top of the pad on the glute-ham developer. However, this makes the exercise easier, so hamstring activity is reduced.

To compensate for this, you can use bands or hold onto a dumbbell to increase the challenge on the glutes as well as the hamstrings. Holding onto a dumbbell is the best method for targeting the glutes, but bands appear to have the edge in terms of hamstring activity.

If your knees are near the very top of the pad of the glute-ham developer, then the exercise is highly similar to the Russian leg curl, both in kinematics and kinetics.

As an aside, many individuals perform the glute-ham raise with their feet lower than the glute ham pad. This makes the exercise much easier, so it may be appropriate for beginners. But for advanced lifters, the feet should be above the glute ham pad. This increases tension on the hip extensors.

Back to the chart. Check out the levels of hamstring activation. Pretty impressive. Now look at the levels of glute activation. The highest activity you get is when holding a 50-pound dumbbell on the glute-ham developer with the knees positioned far away from the pad.

Furthermore, if you think about it, all the glutes are doing in the glute ham raise are contracting isometrically to stabilize the torso. Dynamic contractions are better for muscle growth and strength compared to static contractions.

With the hip thrust, you get much higher mean and peak activation compared to the glute-ham raise, plus you get a dynamic muscle contraction with a concentric, isometric, and eccentric component.

If this isn't enough evidence for you that the glute-ham raise isn't much of a glute exercise, then maybe the next section will change your mind.

For the following calculations, I'll consider a model of a Russian leg curl performed off a poor man's glute-ham from Sorinex as it allows for simpler calculations due to the segments being parallel with the ground at the bottom of the movement.

And I'll assume that the lifter is strong enough to be able to curl himself upward by himself without any push-up assistance, which is actually quite a generous assumption because most guys can't. But I'll be nice for argument's sake.

Let's say you have a six foot, 220-pound male of normal proportions. We need to examine the superincumbent bodyweight; that is, the portion of the body directly acting on the joint in question.

In this case, let's consider the head, arms, and trunk (HAT) because these act on the hip joint. The HAT will weigh around 65 kgs (143 pounds, or 637 Newtons).

Now let's add in the hips and thighs as this will act on the knee joint. His head, arms, trunk, hips, and thighs will weigh around 88 kgs (194 pounds, or 863 Newtons).

By the way, I'm using data from Plagenhoef, et al., 1983, and de Leva, 1996, to formulate my estimations, and these articles also allow for the estimation of the center of mass of the collective segments in question.

The center of mass for the HAT will be around .4 meters from the hip joint center, and the center of mass for the HAT plus thighs will be around .6 meters from the knee joint center.

To calculate the hip extension torque at the bottom of the ROM, we must multiply the lever length by the load. So (637 Newtons) x (.4 meters) gives us 255 Nm of torque at the hips, which is borne primarily upon the glutes and hamstrings.

To calculate the knee flexion torque at the bottom of the ROM, multiply (863 Newtons) by (.6 meters) which gives us 518 Nm of torque at the knees, which is borne upon the hamstrings and gastrocs.

To reiterate, the hardest part of the Russian leg curl requires 255 Nm of torque at the hips (the stronger joint), and 518 Nm of torque at the knees (the weaker joint).

Athletes tend to have around 60-85% more hip extension torque capacity than knee flexion torque capacity (Poulmedis 1985, Smith, et al. 1981). So in the Russian leg curl, you're getting 203% more joint torque at the knee compared to the hip, but the hip is 60-85% stronger in extension than the knee is in flexion. As you can see, the Russian leg curl is a hamstring dominant exercise.

Still not convinced that the glute-ham raise isn't a good glute exercise? Then maybe the next section will finally convince you.

Earlier I discussed how the glute-ham raise simply involved a static glute contraction.

Think about it. If you take the knee-flexion component out of the glute-ham raise and just held an isometric back extension for time, you could probably hold it for 60 seconds, if needed. Obviously knee-placement would matter, and if the knees were on top of the pad it would be more challenging.

Nevertheless, the horizontal back extension iso-hold off the glute-ham developer would be an endurance event, not a strength or power event.

Furthermore, most of my clients can bust out 50 reps on the back extension with their bodyweight. Some can do 100 reps. Again, an endurance event. But the back extension (should be called hip extension) is a better glute exercise than the glute ham raise for several reasons.

• You position the hips closer to the pad, which leads to higher glute activation.
• You can posteriorly tilt the pelvis as you extend the hips, which increases glute activation.
• The back extension involves dynamic contractions and not static glute contractions.
• With the glute-ham raise, the hamstrings fatigue so fast that the glutes don't develop much fatigue at all (and therefore no metabolic stress). On the other hand, with back extensions, depending on how you do them, the glutes can be the "limiting factor" and can fatigue maximally.

The glute-ham raise and Russian leg curl are ass kickers in a figurative sense, but in a literal sense? Not so much.

They're amazing hamstring exercises, and you should definitely do them from time to time, but they're not very good glute exercises, activating only around 5% mean glute activation when normalized to proper MVC position (which is an isometric quadruped hip extension while contracting your glutes as hard as possible).

If you hold onto a dumbbell and position your knees far away from the glute ham pad, you can get up to around 30% mean glute activation and over 100% peak glute activation. But you can get much higher when performing barbell hip thrusts, or even weighted back extensions.

So if your hammies are the primary focus, then do glute-ham raises and/or Russian leg curls. If your glutes are the primary focus, do barbell hip thrusts.

Author's Note: If this article is right down your alley, please check out Hip Extension Torque: The Scientific Guide to the Posterior Chain. It's filled with explanations, graphs, and charts pertaining to the biomechanics and research involving glutes, hamstrings, squats, deadlifts, split squats, good mornings, back extensions, 45 degree hypers, hip thrusts, kettlebell swings, and much more.

1. Ebben WP. Hamstring activation during lower body resistance training exercises. Int J Sports Physiol Perform. 2009 Mar;4(1):84-96. PubMed.
2. de Leva P. Adjustments to Zatsiorsky-Seluyanov's Segment Inertia Parameters. J Biomech. 1996 Sep;29(9):1223-30. PubMed.
3. Plagenhoef S et al. Anatomical data for analyzing human motion. Res Q Exerc Sport. 2013 Feb;54(2):169-178.
4. Poulmedis P. Isokinetic maximal torque power of Greek elite soccer players. J Orthop Sports Phys Ther. 1985;6(5):293-5. PubMed.
5. Smith DJ et al. Isokinetic torque outputs of professional and elite amateur ice hockey players. J Orthop Sports Phys Ther. 1981;3(2):42-7. PubMed.
6. Zebis MK et al. Kettlebell swing targets semitendinosus and supine leg curl targets biceps femoris: an EMG study with rehabilitation implications. Br J Sports Med. 2013 Dec;47(18):1192-8. PubMed.